Dryzone Anti-Mould Additive 100ml Concentrate to Make 5L of Emulsion, Vinyl, Silk or Matt Paint
About this deal
The Dryzone Anti Mould Additive adds mould-resistance to gloss paints, wallpaper paste and grouts preventing the growth of mould on the dried surface. This provides peace of mind that the contained biocides are approved for use and safely incorporated into our products. Rempro Mould Paint Additive should be added to emulsion paint and applied to areas affected by the effects of condensation.
Bio-Wash Moss Remover, is the maintenance professional’s choice for controlling troublesome moss growth on exterior hard surfaces like tarmac driveways, block pavers, sandstone paving slabs, concrete slabs, walls and much more. After walls have been cleaned, you may re-paint your walls again by mixing this additive with the paint to prevent future growth. c) With the same measured solution as above, gently wipe the whole area again to remove any remaining mould residues. Black spot mould is both unsightly and potentially hazardous to human health as the spores aggravate and in some cases, trigger respiratory problems such as asthma.It attacks the problem of mould and condensation in TWO ways by combining micro‐ bead vacuum technology to reduce condensation with a powerful active film fungicide to arrest further mould growth. VC175 Tropical Strength Mould Killer is a powerful, long-lasting mould and algae killer which can be added to a wide range of products such as paint, timber stains, textured coatings, grout, mortar and adhesives to prevent the formation of mould and mildew. Whether you are looking for one product or a full decorators kit, you rest assured that we have all of your needs covered. b) Wearing normal domestic rubber gloves (as you would when using bleach), sponge or wipe onto the affected area.
This product will help clean and kill off very heavy growths prior to application of the AdPaint treatment. Carefully open the Mould Eradication Additive container and add the entire contents to the paint (1 x 50ml of Mould Eradication Additive is enough to convert 2.Spray existing green mould and moss with “ Kingfisher Bio Wash”, leave for 7 days to activate and then scrub or pressure wash to create a clean surface. Such surfaces may be “keyed” with a power orbital sander or some may respond to priming with Kingfisher Floor and Wall Seal or Weatherflex Stabilising Solution Care should be taken when sanding any pre‐1960s wood or metal finishes as these may contain harmful lead. We reserve the right to make any changes according to technological progress or further developments. Green mould on brick, stone and rendered finish is a common problem especially in areas shaded by summer tree foliage. For areas of heavy mould/fungi/mildew growth we recommend using AdPaint Primer - Anti-mould Surface Pre Treatment.