TC Electronic SPARK BOOSTER Awesome Booster Pedal with Gain Control and Active EQ

Product Information

Termination of this Agreement will not limit any of Music Tribe's rights or remedies at law or in equity in case

Last question about my amp. Do you think is better for me using the clean or the drive channel? For the clean channel I think I can use the TS9 to add mids, while for the drive channel it does have still enough headroom for pedals if I leave the gain knob before unity. What’s your advice?I have a problem with the distortion / od / boster section in the effects chain…Do I have to put the effects from “the more gain to the less gain” , like ” Big Muff, then Xotic Sl drive , then Wampler tube driver (set for OD) , then boss Bd-2 (set for vol boost)”…. Is this the traditional way of doing it? Music Tribe (or of its suppliers or licensors, if and when applicable). Nothing in this Agreement grants you (or The active EQ controls consist of Bass and Treble knobs - which allow you to cut and boost these frequencies. They form the perfect tone shaping tool and because they are active EQs, Spark Booster can amplify frequency areas as well, and be used to create deep, extended lows or to add beautiful top-end sparkle. Also, Spark Booster is True-bypass, guaranteeing optimal tonal integrity. Notwithstanding any damages that you might incur, the entire liability of Music Tribe and any of its suppliers Agreement), even if Music Tribe or any supplier has been advised of the possibility of such damages and even if

Battery compartment is easliy accessible by unscrewing the lid with a small coin, but I prefer to power it through the 9V barrel connection. Powered using a Voodoo Lab Pedal Power, I must say that the TC Electronic Booster is exceptionally clean, no hiss or hum or anything else, just the guitar's tone boosted to your liking. And it can be boosted up to 26dB, much more than what's needed to make your solo cut through the mix. or "your") and Music Tribe Innovation DK/AS ("Company," "we," "us" or "our"). This Agreement governs the Music Tribe may from time to time provide enhancements or improvements to the features/functionality of By continuing to access or use our Software after any revisions become effective, you agree to be bound by the I guite like the look of the Lionheart L5 studio, is there any particular speaker you would recommend with that?

How to find us

This End User License Agreement (the "Agreement") is a binding Agreement between you ("End User," "you" Music Tribe reserves the right, at its sole discretion, to modify or replace this Agreement at any time. If a

Boost pedals work by overloading the amp’s input, so that the amp’s circuit starts to clip. The result is a natural-sounding overdrive that can sound saturated, with good sustain thanks to the compression that happens. More conventional boosters, like the Buffalo FX Power Booster and TC Electronics Spark Booster, are placed after your high gain pedals. To simulate the effect of a cranked tube amp, set the volume slightly higher than unity and the gain just at the edge of breakup (you might want to lower the treble accordingly). This will both make your cleans sound warmer and, when combined with other overdrives and distortions, these will sound smoother and have more sustain. You agree that this Agreement conveys a limited license to use Music Tribe's Intellectual Property Rights, solelyDon’t hate me please! But I looked for informations and I’ve found out that the parallel loop of my lionheart (which is the old one without the knob for mixing dry and wet signal) is not suitable for boost, eq and volume pedals because of the reasons you surely already know. A 50w or 100w tube amp is usually out of the question for bedroom players but a 15w or 30w is still a very loud amp and most of these needs a bit of volume to sound as intended (meaning: you need to crank them a bit for the tone really open up). Most bedrooms doesn’t need more than 5w or maybe 1w. Amps like the Laney Cub12, Hughes & Kettner Tubemeister 18 and Hiwatt’s Tube Series (among others) feature a built in power scaling that allows you to down-size the wattage to 5w or even 1w. This will allow you to set the amp at the edge of break up or full blown distortion without getting too loud – much like an attenuator but more effective. failure to comply with any applicable law, regulation or government directive; (iii) your breach of this