Grease Injector Needle

Product Information

My pleasure at succeeding at getting out of the house was soon interrupted by a creaking squeaking sound.

Grease Injector Needle - Lubrication UK

This particular evening I’d made a particular effort, once home, to prise myself immediately into my Lycra armour and get in an hour-long ride. It’s difficult to know, simply from t’imternet browsing, what other products might work. I was therefore resigned to paying up that 40 squid for the official Speedplay grease gun. If you’re someone that greases brake and gear cables within their housings (there seems to be some debate as to whether you’re meant to), a syringe like this will give you the best chance of getting the lube at least in the general vicinity of the opening of the outer sheath. You Mentioned Lubing Speedplay Cleats?

And when applications require high-speed dispensing or dispensing over uneven surfaces, EFD recommends jet valvesfor the greatest accuracy, within tight deposit tolerances. Though this latter fear was mitigated by the knowledge that the amount of power I put through the pedals is unlikely to wear down bearings made of soap.) The added resistance was no doubt helpful in supercharging my training effect, but not ideal if I’m trying not to wear down the pedal bearings. I rode the remainder of the ride in that state of heightened tension where you’re conscious of the ludicrous noise that is piercing through the otherwise peaceful June countryside evening and the potential damage that each pedal stroke might be making.

SGB20S Electrolube, Grease, Contact Treatment Grease, Syringe

Pro tip: keep plenty of kitchen roll – or your alternative cleaning towel of choice – to mop up the spent grease as it comes out. Even then, I found that more old grease came out on my next couple of rides (hence why it’s still there on these photos, a week after the actual greasing). Fill the syringe with the chosen lubricant. In testing Ive tried to use Servisol silicone grease with not much success becasue of the difficulty with pushing the grease through the needle of the syringe. To remedy this issue I recommend a grease with a NLGI grade no greater than 2. This method works well to stop rattle and the application of the lube/grease is very consistant with each application and is a very precise way to apply grease/lube with no overflow which are the problems that I wanted to solve. Is the method better than just dipping the wire in the grease/lube? No, it works just as well so its up to you which method you use but imo its easier to get a consistant application with the method in this post.Part of the reason for putting off the act of maintaining the Speedplays for so long is that the cost of the official Speedplay grease gun seemed so prohibitively expensive. What cant be seen clearly in Figure 4 is that both sides of the wire is being injected with the grease so as much of the empty space is being filled. Here is a sound test the lubed stabilizer versus an unlubed stabilizer to compare, the keycap used is the ansi enter key from MT3 Serika. On the second pedal though it just didn’t want to play. A very small amount of grease oozed out of the other side but it was gushing – POSITIVELY gushing out of the pedal on the side that I was trying to insert it. I got even more on the floor, my jeans, the wall and the drive.